Save 10% on any Tel-Tru product use coupon code 2019-tel at checkout.
We used this grill lid thermometer to replace the stock thermometer on our Weber Spirit gas grill. It dropped right into the bezel. Read the entire story here.
Made in the USA Tel-tru model number BQ100
If you are looking to replace the stock thermometer on your grills lid you need to consider some important measurements. First is the size of the face and the best way to do this is to remove your existing grill hood thermometer and measure across the hole in the bezel that it came out of. Like most grill lid thermometer this thermometer will not sit flush against the hood and the bezel not only makes it look better it also stabilizes the face. This Tel-tru grill lid thermometer has a 1 3/4 inch dial face. There is a larger dial face available.
The next thing to consider is the length of the threads on the back of the thermometer. This is to ensure that they are long enough to be able to tighten the nut. when you install the new one. Simply measure the threads on your existing lid thermometer for this. It is acceptable for the threads of your replacement to be long but not short. The threads on this Tel-tru grill lid thermometer are just under 3/4 of an inch long.
The final thing to consider is the length of the probe. The stem length on this one is 2.13 inches. That measurement is from the thermometer back including the threads.
To remove your old grill lid thermometer: Raise the hood of your grill and look at it from underneath. On most grills you will be able to see the thermometer stem and nut. Find the appropriate tool to loosen the nut and while putting slight pressure on the dial from the outside turn. Once it is a little loose you can hold the nut by hand and turn the dial from the outside to remove it all the way.
Installation of your new Tel-Tru BQ100 grill lid thermometer:
If you took your measurements right, installation is as easy as placing your new thermometer into the hole and tightening up the wing-nut from the back. It only needs to be hand tightened. Before you fully tighten the nut make sure the face of the thermometer is straight up and down and apply a little pressure to the face when making that last turn.
To install a new thermometer into a grill that does not have an existing thermometer. You will need to drill a 1/4 hole first.
1.75 inch dial
2.13 inch stem
1/4″-20 threaded bushing with wing nut